返回列表 發帖

ground clearence

攪牙可以增加factory ground clearence嗎﹖


如果原廠=150mm
after market攪牙(意指普通攪牙﹐唔使遙控油壓)可以把它增至200mm嗎﹖

而家拍車(parking經常車底撞碎冰﹐車底好似有好多野可以刮exhaust pipes, brake lines, stablizer bar, axle, joints, cat, ......w/e

I don't think it's wise to do that cuz your brake lines only have a certain amount of travel, plus other suspension parts like sway bars might restrict this.  5cm is a lot!  You need a lift kit to increase ride height.

TOP

150 mm is a lots la..  

no need ...

TOP

forgot what car u drive, but i haven't seen any coilover that can make the car higher than stock for a long time (so i dun even remember if that exists!)

some, even set to highest spot, can still be 15mm less than stock....

for some cars, like honda with koni shocks, u can run stock springs and put it one groove higher; friend tried that and eventually the lock ring underneath doesn't hold (probably rusted out and way too much stress from spring pressure), it breaks and damaged the strut body too...will take weeks to order that lock ring and he was sooooo screw...

so far i am driving all my lowered cars around okay, as long as it's not slammed (always, try to have 1 finger gap at least), all u need is snow tires
我係5 Zigen :P

TOP

CP: he is saying raising 5cm, still a lot, ppl normally lower 25 to 50mm (and it can already be slammed)

btw librazhy, what u have to worry is transmission / radiator / radiator support (part of the body, which is quite weak) / exhaust will scrap the most...dun worry about ur axle, sway bar, brakelines, those usually shouldn't be in the way...

exhaust is usually quite hot so it might melt some snow or ice, oil pan / transmission / radiator is what ppl are having problem these days...
我係5 Zigen :P

TOP

返回列表